I think you are speaking about the bushings that are in the top of the axle, that attaches the upper control arms to the rear axle? Right?? Well... a few weeks ago I install new ones, some from energy suspension, and all I did was push them in as hard as i could by hand and then beat them in with a hammer... Worked great! I tried a c-clamp to push them in and that hardly budged it. Just hit it on opsite and go around a circle and do that. Get it? The busing should have a lip, that will fit tight up against the rear axle. Hope that helps!
------------------
Joe Zemaitis, Grand Rapids Michigan
1991 Mustang GT. Mods to date: 4.10 rear end, new POSI, aluminum driveshaft, AOD w/ shift kit, 2 1/2 off road h-pipe, 2 1/2 flowmasters and 2 1/2 tail pipes. Electric fan, Removed air pump and egr tube. Jegs brand upper and lower adjustable control arms. Removed back seats. Hoosier Quick Time Pro 27x10.5x15 and bolt on subframes soon to be welded. Everything else is STOCK. Totally stock ENGINE. 14.29@96 with 130k miles.
|