MustangWorks.com : Ford Forums - View Single Post

evilmustang · 12-10-2001, 07:15 AM

Hey guys.
I’m currently installing a set of 58cc Stud mount AFR 165cc on my Stang. My Girlfriend has been observing how hard I’m working on the process and suggest I just go ahead and get the complete up and lower intake. Now the question what would be the best intake for this setup?
Would the Performer RPM be too much for this setup? Its my daily driver, and I don't want to loss to much low end.
What do you guys think would be the best intake? Also, will the stock throttle body and EGR bolt up to an new intake system? I will replace the Throttle body/EGR later but for now I will use the stock setup.
Check signature for current setup.

12-10-2001, 07:15 AM	#1
evilmustang Registered Member Join Date: Jan 2001 Location: compton, CA, USA Posts: 63	Intake for AFR 165 Hey guys. I’m currently installing a set of 58cc Stud mount AFR 165cc on my Stang. My Girlfriend has been observing how hard I’m working on the process and suggest I just go ahead and get the complete up and lower intake. Now the question what would be the best intake for this setup? Would the Performer RPM be too much for this setup? Its my daily driver, and I don't want to loss to much low end. What do you guys think would be the best intake? Also, will the stock throttle body and EGR bolt up to an new intake system? I will replace the Throttle body/EGR later but for now I will use the stock setup. Check signature for current setup. __________________ 90LX Coupe T-5, stock 302 with 120,000 Holley 155 FP, BBK equal length, Flowmaster 2chamber cat-back, underdrive pulleys, 3.55 gears, Eibach springs, Tokico non-adj shocks, weld in subs. 210 rwhp (goal 300rwhp)