hey Kevin, Drew here, what kind of machining do you do in your shop? i had 3 years of machining in highschool and i worked in a maintenence shop at Lilly as a machinist-trainee, i never knew you were a machinist, would you know if your shop is in need of a little part time help (in school) or if they ever use summer help? i miss it too and dont want to forget everything
------------------
88 Notchback 5.0, 3.73's, pulleys, BBK headers, off-road H-pipe, flowmasters, subframe connectors, 65mm TB, shift kit, March ram air kit, motorsport wires, MSD coil, upper and lower control arms, 155lph fuel pump, cheap 2800 stall, Crane Adj.FPR, best time- 13.99@99.75, not yet tested times after 1.7RR install
