Linear Mode
© Copyright 1995 thru 2008 - The Mustang Works™. All Rights Reserved.
MustangWorks.com is designed and hosted by Aero3 Media.
MustangWorks.com is designed and hosted by Aero3 Media.
06-15-2002, 10:03 PM
|
#1 |
|
Registered Member
Join Date: Dec 2000
Posts: 168
|
just finished the heads...how long til...
I just bolted her all back up, cranked it over, and all seems to be good (except the darn loose water hose clamp, which I thought was the intake gasket leaking!) WHEEEEW!
how long until I can get it out on the road, will all the RTV on the lower intake be cured after about 11 hrs? tube reads fully set in 24hrs...I had it sitting at idle for a while while getting the coolant filled... and what are some tell tale ways to make sure it is all tight? problem areas, weak spots, easily overlooked things, etc.? What is the break in on new heads, like go easy for 50 miles or anything like that? thanks a bunch!! |
|
|
 |
|
|
Similar Threads
|
||||
| Thread | Thread Starter | Forum | Replies | Last Post |
| 71 2v Cleveland heads on a mild 302 | crazypete | Windsor Power | 3 | 06-18-2004 07:05 PM |
| Whats the difference in GT40 and GT40P Heads? | RoushRacing6N17 | Windsor Power | 2 | 11-17-2003 11:52 PM |
| Price estimate for barely used Edel. Perf. RPM alum. heads w/ 2.02/1.60 valves?? | Simi Stang | Windsor Power | 13 | 11-03-2003 11:23 PM |
| is there any difference between 351C heads and 351M heads | tireburner163 | Windsor Power | 7 | 03-09-2001 09:26 PM |
| Is the true about Edelbrock heads with TFS intake? | gt93mustang | Windsor Power | 14 | 03-06-2001 07:01 PM |