[HiFlow5 0]

Originally posted by Mach 1
Remove your intake hose for some extra room. Pop the TV cable off of the TB bracket with a screwdriver.

Roll it over, and then youll see a white thing on the bottom. With a small screwdriver, push in on the white thing, sliding it up. This will release the "adjustment mechanism" from the cable, and you should be able to slide the mechanism back and forth on the cable. make sure it slides freely with no binding.

then, while holding the TB closed against the idle stop screw, push the TV cable into the TB bushing, which will push in the pin at the same time you are going into the grommet. thus locking the cabe to a position that is TV valve on tranny fully closed, while the Throttle body is fully closed.

Is that how you adjust the TV linkage? I thought there was another step to it. Just becareful cause you can fry the AOD if its not done properly!!