Threaded Mode
© Copyright 1995 thru 2008 - The Mustang Works™. All Rights Reserved.
MustangWorks.com is designed and hosted by Aero3 Media.
MustangWorks.com is designed and hosted by Aero3 Media.
08-26-2004, 04:18 PM
|
#1 |
|
Registered Member
Join Date: Feb 2001
Location: Berkshire County - Massachusetts
Posts: 735
|
Leaky power steering pressure line problem
I just put in a new power steering pressure hose and it leaking already. THe instructions say not to torque past 15lbs. Any advice on how to stop the leak? The nylon o-ring doesn't seem to be getting the job done...this is really start to pi$$ me off bigtime. It's leaking right out of the thred onto the ground with a constant drip.
__________________
Red 1993 GT Street Machine Best E.T. - 12.41/Best MPH = 108 Engine is a 1969 351 block w/393 stroker kit. Dynamic Roller Myte C4, 8 pt cage. Edlebrock Performer heads and Victor Jr. EFI, FRPP 30lb injectors & Cartech fuel system. MSD ignition. Sothside Machine bars & Sub-frames, adj. upper's, 3.73's, Koni rear shocks, much more |
|
|
|
|
Similar Threads
|
||||
| Thread | Thread Starter | Forum | Replies | Last Post |
| 1970 mach 1 power steering hoses | ken testa | Classic Mustangs | 0 | 03-11-2003 10:19 PM |
| Best way to remove power steering. | Dark_5.0 | Windsor Power | 1 | 11-07-2002 01:41 PM |
| Power Steering | nicolette | Classic Mustangs | 2 | 03-20-2002 01:06 PM |
| Power steering | Mike67coupe | Classic Mustangs | 2 | 01-01-2002 08:37 AM |
| Power Steering Pump | evilmustang | Windsor Power | 5 | 07-22-2001 09:25 AM |