Threaded Mode
© Copyright 1995 thru 2008 - The Mustang Works™. All Rights Reserved.
MustangWorks.com is designed and hosted by Aero3 Media.
MustangWorks.com is designed and hosted by Aero3 Media.
01-16-2003, 01:14 PM
|
#1 |
|
Registered Member
Join Date: Jul 2002
Location: Indiana
Posts: 51
|
Lets talk camshafts
Hey folks, I have a question. First, I tried to do a search and I must be blind, but I really couldn't take away much from some of the previous posts.
Anyway, I am building a DSS 306 w/ forged pistons. I have a set of AFR 185 heads. The motor is running about 10:1 comp. I have a brand new set of FMS 1:7 rockers that I would like to use. This car will not be emisson legal. It will also be half drag strip and half street use. I am looking for a roller with a pretty lopey idle. Any suggestions would be greatly appreciated.  P.S. It is a 5spd, and it will be injected. I have an extrude honed Cobra upper and lower. Also this car will not have any power adders for now. Last edited by 306bullet; 01-16-2003 at 01:33 PM.. |
|
|
|
|
Similar Threads
|
||||
| Thread | Thread Starter | Forum | Replies | Last Post |
| Speed Density and Camshafts | gtsr515 | Windsor Power | 4 | 08-05-2019 07:13 PM |
| Bored at work...wanna talk | Mustang_grl | Blue Oval Lounge | 33 | 05-03-2003 09:50 AM |
| Talk about lame | moponys | Windsor Power | 8 | 11-11-2002 07:49 PM |
| Talk about bad decisions... ;) | Hammer | Blue Oval Lounge | 5 | 05-03-2002 05:14 PM |
| What's up with all the trash talk? | QuantumMotorsports | Stang Stories | 51 | 01-04-2001 06:37 PM |