Threaded Mode
© Copyright 1995 thru 2008 - The Mustang Works™. All Rights Reserved.
MustangWorks.com is designed and hosted by Aero3 Media.
MustangWorks.com is designed and hosted by Aero3 Media.
11-22-2001, 03:52 PM
|
#1 |
|
Registered Member
Join Date: Oct 1998
Location: Ruthven, On. Canada
Posts: 32
|
Retro-fit roller cam for 358
I need some insight here. The motor has AFR 185's, 1.6 roller rockers, 10.5+ comp., TFS intake, 36lb. injectors, 70mm TB, 76mm C&L w/pipe, also vortech fuel rails and braided lines front to rear. There's no problem with anything else just a decision on which cam to use. The rev limiter is not a concern anymore, but the motor still has it's factory rods. It needs to be semi-close to being emissions legal as well. Thanks.
__________________
1970 Torino GT convertible-429cid 2003 Mustang GT 1989 Mustang LX |
|
|
|
|
Similar Threads
|
||||
| Thread | Thread Starter | Forum | Replies | Last Post |
| building a stroker need advice on solid roller or hydrallic roller cam ?? | Mustangboy89 | Windsor Power | 4 | 06-06-2003 02:10 PM |
| Solid Roller ? | STROKER BILLY | Windsor Power | 5 | 11-19-2002 12:04 AM |
| 351W roller conversion | Capri306 | Windsor Power | 4 | 02-14-2002 04:49 PM |
| hydraulic roller valvetrain for HP street?? | Stang_ROTY | Windsor Power | 2 | 04-27-2001 01:09 AM |
| Non roller to roller 351 block ????? | 88workcar | Windsor Power | 2 | 03-04-2001 12:45 PM |