MustangWorks.com : Ford Forums - View Single Post - Machining on a stock throttle body

2FastLX · 03-29-2001, 10:34 AM

Tomorrow I am adding a GT-40 intake, ported ET7E heads, F303 cam, Crane springs, 1.6 roller rockers, 76mm C&L MAF, 24lb injectors, 190lph fuel pump, cold air kit, A/C delete kit, removed smog pump, battery relocate kit, and a few minor goodies.

I'm stoked as hell right now becase my cam and springs just arrived and that was the final component I needed to put her back together besides a throttle body.

3.73's will be installed in a couple weeks.

------------------
ICQ# 42269241
Indiana Stangers Association
Buy your parts here

03-29-2001, 10:34 AM	#6
2FastLX The Photoshop Guru Join Date: Feb 2001 Location: Mecca, Indiana Posts: 1,419	Tomorrow I am adding a GT-40 intake, ported ET7E heads, F303 cam, Crane springs, 1.6 roller rockers, 76mm C&L MAF, 24lb injectors, 190lph fuel pump, cold air kit, A/C delete kit, removed smog pump, battery relocate kit, and a few minor goodies. I'm stoked as hell right now becase my cam and springs just arrived and that was the final component I needed to put her back together besides a throttle body. 3.73's will be installed in a couple weeks. ------------------ ICQ# 42269241 Indiana Stangers Association Buy your parts here