© Copyright 1995 thru 2008 - The Mustang Works™. All Rights Reserved.
MustangWorks.com is designed and hosted by Aero3 Media.
MustangWorks.com is designed and hosted by Aero3 Media.
04-19-2001, 09:57 PM | #1 |
Import Slayer
Join Date: May 1999
Posts: 2,241
|
I made my decision!!!!
I mentioned in an earlier post that I was thinking about trading my Alpine system for an '89 4 cyl coupe so that I could swap the engine/tranny/exhaust from my '82GT.
I decided that I am going to trade the guy and begin a new project!! I am thinking that the coupe will be lighter thus quicker than the GT body. I am also going to eliminate every extra pound of weight that I can. I estimated that my GT would have ran high 13's and I am looking for low 13's with just a chassis swap and weight trimming. Do you think that is possible or will I still need more engine mods for low 13's? ------------------ '82 GT 351W C-4,BBK headers,Carter 625 carb,Comp.Cam,Flowmaster exhaust. 1988 GT...T-5,bone stock |
04-19-2001, 11:43 PM | #2 |
Registered Member
Join Date: May 1999
Posts: 5,246
|
I really doubt an '89 Coupe weighs any less than your '82GT, dude.
According to the NADA website, the 86GT weighs in at 3000 lbs, so does the 87 5.0 LX Coupe. If you are looking to shave 1/2 sec, your gonna need more engine or performance mods. I don't think you're gonna be able to get more than a couple hundo out of the coupe before weight savings gets slim. |
04-20-2001, 03:43 PM | #3 |
Import Slayer
Join Date: May 1999
Posts: 2,241
|
No Way, That can't be correct. Coupes are usually always lighter than the hatchbacks and converts. Did you every try to carry one of those hatches from a hatchback? Try it....they are freakin HEAVY!!
I'll check on it but I still think the lightest mustang you can get is an LX coupe. I don't think they make those anymore though. ------------------ '82 GT 351W C-4,BBK headers,Carter 625 carb,Comp.Cam,Flowmaster exhaust. 1988 GT...T-5,bone stock |
04-21-2001, 02:17 AM | #4 |
Sober voice of Reason
Join Date: Nov 1998
Location: Kelowna, B.C., Canada
Posts: 1,514
|
I don't think you'll be much, if any at all, lighter. The 82gt's stock curb weight is only a few pounds heavier (3049 vs 3027 according to Insurance Corp. of British Columbia Data) than an 87-89 4 cyl. notch and that is with the 4 cyl. I think it would be a lot of effort for a marginal improvement.
The hatch may feel heavy compared to a trunklid but add in the weight of the rear window and the piece that goes across the base of the window. The difference is not that big. To drop 5/10ths you'd need to drop at least 300lbs, there is no way that coupe is 300lbs lighter than an 82gt. ------------------ GT-40 heads (ported, polished, + milled), B303 cam, 1.7rr's, JE pistons, Offy intake, Carter AFB 625cfm carb, Flowtech 1 5/8" shortys, Flowtech X-pipe, MAC Flowpath exhaust, MAC pulleys, 373's, subframes, Eibachs+Tokicos, B+M ripper, FMS Clutch, Zoom Quadrant+cable, 17" CSA Ultra rims, 235/45ZR17 Yokohama AVS S4's, MSD 6A ignition+coil, FMS 9mm wires, Carbed, Naturally Aspirated, and Nasty! |
04-21-2001, 01:28 PM | #5 |
Registered Member
Join Date: May 1999
Posts: 5,246
|
Yes, I actually have carried a hatch before. They are heavy, but if I can carry it, it's certainly not more than 150lbs. And like was posted, you have to compare that to the coupe's trunk, and rear glass. Not much of a difference anymore after you do that.
Anyway, my data was obtained from the www.nada.com website. It listed 1986 GT Hatch 5.0 3000 lbs 1987 LX Coupe 5.0 3000 lbs 1987 LX Hatch 5.0 3059 lbs 1987 GT Hatch 5.0 3080 lbs |
04-21-2001, 02:49 PM | #6 |
Import Slayer
Join Date: May 1999
Posts: 2,241
|
I was making the swap just because I thought it would be lighter. The 89 is in much better condition and the wiring harness in my '82 is fried, which I really don't want to mess with anymore.
I just thought maybe I would be a little bit lighter as a bonus but I guess not. Oh well, I'll have a car in better shape and a summer project. ------------------ '82 GT 351W C-4,BBK headers,Carter 625 carb,Comp.Cam,Flowmaster exhaust. 1988 GT...T-5,bone stock |
04-21-2001, 05:50 PM | #7 |
Registered Member
Join Date: May 1999
Posts: 5,246
|
I'm not jumpin on you, just letting you know the facts honestly.
I would have done the trade if I was in the position too. Lata Unit 5302 |
|
|
Similar Threads | ||||
Thread | Thread Starter | Forum | Replies | Last Post |
Made the decision...I'm stepping up to Victor Jr EFI | Stang_ROTY | Windsor Power | 11 | 08-18-2004 08:09 AM |
Went w/ the MAC longtubes..I hope I made the right choice | Stang_ROTY | Windsor Power | 1 | 06-20-2003 10:01 AM |
were there any 85-92 Cobras made? | Kamaro Killer | Blue Oval Lounge | 3 | 09-12-2002 02:29 PM |
Made the decision....Going with the Lentech!! | Stang_ROTY | Windsor Power | 23 | 06-16-2002 10:53 AM |
Who really cares? | PKRWUD | Blue Oval Lounge | 17 | 02-21-2002 11:48 PM |