MustangWorks.com : Ford Forums - View Single Post

RUSTANG · 07-31-2002, 12:32 PM

I bought the manual brake conversion kit from Holcomb but did not get the kit with the master cylinder included, just the rod and firewall block. I bought a 86SVO master cylinder to go with it but it is made for Power brakes and the rod is not long enough to work with it. It has a sunkin rod hole in it about 1 1/2 inches deep. My brake pedle is only 3 inches off the floor due to this. What master cylinders are you using with your kit's? Any help would be greatly appreciated!

Thanks

07-31-2002, 12:32 PM	#1
RUSTANG Registered Member Join Date: Jan 1999 Location: Dale City Va. Posts: 516	Manual Brakes Q'S I bought the manual brake conversion kit from Holcomb but did not get the kit with the master cylinder included, just the rod and firewall block. I bought a 86SVO master cylinder to go with it but it is made for Power brakes and the rod is not long enough to work with it. It has a sunkin rod hole in it about 1 1/2 inches deep. My brake pedle is only 3 inches off the floor due to this. What master cylinders are you using with your kit's? Any help would be greatly appreciated! Thanks __________________ Currently rebuilding my 85 Mustang GT from the frame up. Check out my site for info on my car and specific information on the 85 Mustang. http://www.FlemWorld.com