MustangWorks.com : Ford Forums - View Single Post - Mech. fuel pump cam doesn't fit new timing chain?

7000rpmisheaven · 03-12-2002, 08:55 AM

I will take another look. The tab fits fine. It is the outer piece of the eccentric that rubs. Without the outer piece the eccentric fits fine. I don't plan on spinning it very high and the cam gear only spins half of what the crank does anyways. I think I will install it with just the one piece. After all I can always take it out and try grinding the cam gear if it causes too much heat. Thanks for all the help.

03-12-2002, 08:55 AM	#8
7000rpmisheaven Registered Member Join Date: Nov 2001 Location: germantown MD Posts: 283	I will take another look. The tab fits fine. It is the outer piece of the eccentric that rubs. Without the outer piece the eccentric fits fine. I don't plan on spinning it very high and the cam gear only spins half of what the crank does anyways. I think I will install it with just the one piece. After all I can always take it out and try grinding the cam gear if it causes too much heat. Thanks for all the help. __________________ 85 GT 4bbl roller cam 2 ch. Flowmasters, O/R H-pipe Performer intake and carb milodon water pump, FMS 9mm wires, aluminum driveshaft, king cobra clutch