Mech. oil pressue gauge
 

What is the best way to install a mechanical oil pressure gauge?

I took the factory sender off and used the supplied fitting to attach there.

------------------
Check Out My Site 91GT,Holley SysteMAX II Kit-Heads 2.02" x 1.60" port matched to a 1262,Anderson N-61,24#,76mm C&L,Full MAC exhaust 1-5/8" Long tubes,2-1/2" O.R H-Pipe,2 1/2" cat back, No A/C or PS or emissions, 12" K&N Filter,RNH PERFORMANCE Ram Air,Ron Davis Radiator,Full Suspension,S&W 8pt "X" brace,JAZ seats,3:73's,Welds..etc,4:30's and 31 splines coming very soon! FIRST TIME OUT 12.16@111 WHEELS-UP

I would also suggest using a braided line, not the plastic one that comes with the gauge. Those tend to leak.

------------------
91 coupe
3.73's,long tubes,2 1/2" exh,ported stock t-body,ProM-77mm
cobra intake,edelbrock heads,B303,1.72 rr's
36lb inj's,tremec, & a Paxton NOVI 2000!!!
11.020 @128.95 on BFG Drag Radials (275/60/15)

I assume the ECM does not use the oil pressure signal for fuel shutoff etc like a GM does??? Often it's recomended to attach an aftermarket gauge on a T fitting to retain the stock sensor, but that sounds like a pain huh?

------------------
Frank W
90 5.0 LX coupe Daily driver. Silencer removed, K&N filter. Flexalite fan, 3 core radiator. FMS flywheel and Clutch, FMS blue wires Energy Suspension end links
88 Notch 2.3L 5 speed Parts/beater car My two Notchbacks

74 Chevy Laguna Type S-3 305 Finally fixed getting a 454 to put in garage
<A HREF="http://www.chevellepages.com/folingo" TARGET=_blank>www.chevellepages.