|
moser axels in..rearend built..got a question
they seem to stick out about 1/2" farther than the stock ones so the drums sit out a lil farther..it doesnt look like it would matter..any concern here?
i have a 31 spline tracktion lok and 31 spline mosers ------------------ 1987 black notch(ex 4 banger) DSS 306 w/ main support...Elderbrock 6028 heads..gt-40 intake..24# injectors...70 mm tb..77 pro-m...accel 300+..mac full legnth..tremec w/ pro5oh...full MAC exhaust,off road h-pipe,long tubes, catback...ron davis radiator..subframes, control arms...CFDF II..o yea holley FPR sucks..dont buy one.. AIM=onesillynotch http://cwm.ragesofsanity.com/contrib/owen/scatter.gif |
With C-clip elmininators?
I think as long as the pads are fully seated into the drum and the drum seals to the backing plate well enough, then probems should be minimal? |
nope still got the c-clips but i put the pads on and put a set of drums on it just for testing porpouses and the pads are fully on the drum by a good 1/2" so it looks l;ike it will be fine
------------------ 1987 black notch(ex 4 banger) DSS 306 w/ main support...Elderbrock 6028 heads..gt-40 intake..24# injectors...70 mm tb..77 pro-m...accel 300+..mac full legnth..tremec w/ pro5oh...full MAC exhaust,off road h-pipe,long tubes, catback...ron davis radiator..subframes, control arms...CFDF II..o yea holley FPR sucks..dont buy one.. AIM=onesillynotch http://cwm.ragesofsanity.com/contrib/owen/scatter.gif |
| All times are GMT -5. The time now is 05:35 AM. |