Motor Question
I have a 5.0 in a 93 XR7 and am thinking of a cam swap. I have a cam with these specs--
lobe lift- .322" int/exh
lobe sep-110 deg.
2.06 deg adv
252 deg dur @ .020
221 deg dur @ .050
133 deg dur @ .200
The motor has a stock bottom end, iron pocket ported heads, stock gasket matched intake and exhaust, 3.55 gears and the low gear AOD kit in the trans. Is this a decent cam to put in? I am worried about piston to valve clearance with the stock set-up. I also have 1.7 rockers available- can and should I use them? Any other suggestions would be a great help. Thanks..............
|