MustangWorks.com : Ford Forums - View Single Post

Conman · 10-17-2002, 04:20 PM

thanks guys
I have rebuilt the tranny and replaced that little plastic cup. I think I just need to back off the bolts a little bit. An aluminum driveshaft would probably help to but the vibration is not bad at all, just enough to make it rattle. If I rest my hand on it the rattle stops but that gets tiring.
I wasn't sure if I should back the bolt off or bring it closer to the handle

I will try backing it off a little

10-17-2002, 04:20 PM	#8
Conman Registered Member Join Date: Apr 2002 Location: Kingston, Ontario Posts: 351	thanks guys I have rebuilt the tranny and replaced that little plastic cup. I think I just need to back off the bolts a little bit. An aluminum driveshaft would probably help to but the vibration is not bad at all, just enough to make it rattle. If I rest my hand on it the rattle stops but that gets tiring. I wasn't sure if I should back the bolt off or bring it closer to the handle I will try backing it off a little __________________ '88 lx, Black on Black, check it out here Spent all my money on school, what a dumb mistake I'm old enough to know better, but still too young to care.