Threaded Mode
© Copyright 1995 thru 2008 - The Mustang Works™. All Rights Reserved.
MustangWorks.com is designed and hosted by Aero3 Media.
MustangWorks.com is designed and hosted by Aero3 Media.
03-02-2002, 10:59 PM
|
#1 |
|
Registered Member
Join Date: Apr 1999
Location: Miami,Fl USA
Posts: 297
|
Powerdyne tensioner problem after smaller pullie
After installing a smaller pullie for my 6 psi to boost to9 psi I am having problems with my serpentine belt getting shedded by one of the tensioner bolts. I have the smallest belt I can fit on the blower but I still need to drop the tensioner down far. Is there a way to get a smaller belt on the SC pullie so the tensioner could be set in the higher bolt holes? Or is there a bigger pullie for the tensioner? Right now I am running around with the blower belt off so I don't get stuck again. Man it sucks to be slow.
thanks for the help Chip
__________________
92 GT Convertible Hooker Headers, Headman X pipe, Flow Masters, 4.10s, BBK 1.5 drop, 73mm Mass air, 65 FMS TB, FMS Aluminum radiator, T-5 swap with a Steeda shifter. And a 9 pound Blow Job |
|
|
|
|
Similar Threads
|
||||
| Thread | Thread Starter | Forum | Replies | Last Post |
| Reversing the belt tensioner | Ieatcamaros | Windsor Power | 4 | 08-19-2003 06:04 PM |
| Please help stutering problem | Just me | Windsor Power | 10 | 10-18-2002 02:37 PM |
| Powerdyne 6 to 9 pullie? | Chipdog | Windsor Power | 6 | 07-17-2001 11:03 AM |