|04-20-2015, 12:22 PM||#1 (permalink)|
Join Date: Apr 2015
need help dialing in my swap.
So I own a 1985 corolla (ae86), bought a 1985 carbed 5.0 mustang, tow apart both cars and put the 302 and the t5 in the corolla.
I'm running a bone stock non roller motor with an edelbrock 1406 carb, sn95 factory headers to 2 1/4" pipe to 2 1/2" glass packs, no cats, no h pipe. No tstat and 10 degrees base timing.
Issue I'm having is that about 2 minutes into sustained higher rpm operation (donuts, drifting, etc). My headers area glowing red and the car quickly climbs to 220+ and I've gotta go hot lap it to get the heat down. I've owned foxes before and never had this kind of issue.
My only thought is that I might be fuel starving it due to to small of a feed line, the corolla fuel lines that I reused are metric and the feed is slightly less than 5/16 Id (6mm maybe). I'm going to swap for 3/8 hard line to feed to rule that out.
Hoping for any insight y'all might have
|Display Modes||Rate This Thread|
|Thread||Thread Starter||Forum||Replies||Last Post|
|t-5 swap||halffast82||Windsor Power||1||03-05-2007 11:13 AM|
|anyone know of this swap?||Edelbrock||Built Ford Tough||1||05-25-2005 05:12 PM|
|5.0 swap||7SecYaRight||Windsor Power||0||06-15-2003 01:58 AM|
|Dialing in cam?||BLACK85GT||Windsor Power||3||02-18-2003 05:59 PM|
|5.0 to 4.6 swap||Rownd||Modular Madness||6||02-05-2002 08:06 PM|