Threaded Mode
© Copyright 1995 thru 2008 - The Mustang Works™. All Rights Reserved.
MustangWorks.com is designed and hosted by Aero3 Media.
MustangWorks.com is designed and hosted by Aero3 Media.
04-12-2001, 12:48 PM
|
#1 |
|
Registered Member
Join Date: Jun 1999
Location: Westchester, IL, USA
Posts: 171
|
oil cooler installation
I have a vortech with the high pressure oil inlet, and was wondering if i unhooked the high pressure line from that and then hooked up a oil cooler inline with it, if it would cause a problem with the motor. The only problem I can see is the loss of pressure because of the extra distance that it has to travel. when i was running my car without the blower last week (melted the discharge tube) it ran alot cooler. Also because im at the peak efficiency of the a-trim, it runs REALLY hot.
|
|
|
|
|
Similar Threads
|
||||
| Thread | Thread Starter | Forum | Replies | Last Post |
| Oil cooler | GTSteed89 | Windsor Power | 1 | 05-30-2003 01:58 PM |
| What trany and Oil cooler to use? | Mustvid | Windsor Power | 0 | 05-27-2002 12:41 PM |
| Harder starts after head installation | SlowStang2 | Windsor Power | 5 | 08-10-2001 01:13 AM |
| Walbro inline fuel pump installation | Petey89 | Windsor Power | 1 | 06-22-2001 06:31 PM |
| Tranny cooler line blues | blue00gt | Windsor Power | 0 | 03-02-2001 06:03 PM |