Ok, running Hoosier Quick Time Pro D.O.T drags. On Weld Draglites. tire size: 27x 11.5 x 15 @ 11 PSI. Anything over 4K launch lites them up, not only in 1st. but 2nd also. I can launch at 3600-3700 rpm, but max torque is at 4500.(according to DYNO sheet)
Running a World class T-5 with hanlon 295z gears, and all parts from hanlon. Auborn pro with 456 gears
Chassis. 8 pt cage with cross bars in rear. Full sub frames done by Chassis Designz. Everyone says the car sit too low. but I have the eidbach launch springs. And yes, sway bar is off, and running draglites 4" wide up front. Only thing under the hood is a carbed motor and alternator. I just bought a rolling chassis ( a coupe) and the rear sits noticably higher than mine. Wondering if i should try the springs from it.
I've also been told to install a line lock to really heat up the tires. I drop it in 3rd gear in the water box and get about 3 to 4 seconds of burn out if i try and apply brakes, car swings left or right.
