Threaded Mode
© Copyright 1995 thru 2008 - The Mustang Works™. All Rights Reserved.
MustangWorks.com is designed and hosted by Aero3 Media.
MustangWorks.com is designed and hosted by Aero3 Media.
04-17-2002, 11:10 PM
|
#1 |
|
Registered Member
Join Date: Jan 2001
Location: Kintnersville, PA USA
Posts: 38
|
new motor is in and ready to tear except...
Just dropped in my keith craft 306 equipped with TFS heads, TFS stage 1 cam w/ 1.7 rockers, TFS street intake, 24# injectors, 190 lph fuel pump, pro-m 75mm MAF, etc. I started the engine and it ran for about 30 seconds and idled very rough between 900 and 1100 rpm. The car then stalled. Each time I start it, it will not idle at all. I must keep it at about 2000 rpm to keep it running. I have the fuel pressure at around 40 psi. I know the distributor is in correctly too. Is my fuel pressure too high or is it something else? I don't know where to go from here. Any help or suggestions are greatly appreciated. Thanks for the help!
-Dave
__________________
91 LX: Green/white stripes, TFS heads, intake, cam, and 1.7 rockers. BBK longtubes, off-road h-pipe w/ flowmasters. |
|
|
|
|
Similar Threads
|
||||
| Thread | Thread Starter | Forum | Replies | Last Post |
| new motor is in and ready to tear except... | StripedStangLX | Windsor Power | 0 | 04-17-2002 10:59 PM |
| My '82GT is almost ready!! | 82 GT | Windsor Power | 4 | 07-07-2001 10:26 PM |
| She is almost ready!!! | 88COBRA | Blue Oval Lounge | 2 | 04-23-2001 07:06 PM |
| Ready to Buy - What to Look For? | DEPete | Special Production | 2 | 03-27-2001 12:05 AM |
| Any tips before I tear her apart?????? | gray87GT | Windsor Power | 12 | 01-26-2001 11:22 PM |