Tranny-have it redone. I used a Hanlon Motorsports Master Kit ($225), it came with everything you need. I mean everything.
Bump-rear u-joint replace it and also check your pinion nut while you have the drive shaft out. I replace U-joints every 20xxx in everything I own.
Not sure about the otherstuff but someone on here probably has the right answer.
------------------
'93 lx 4 banger, wrecked '90 lx 5.0, w/ t-5. .030 over fully ported and polihed (did that just to see if I could-first attempt at it). Motor and tranny in use for Ranger project.
Cocked, locked and ready to rock
Pony Power Forever
|