© Copyright 1995 thru 2008 - The Mustang Works™. All Rights Reserved.
MustangWorks.com is designed and hosted by Aero3 Media.
MustangWorks.com is designed and hosted by Aero3 Media.
09-11-2001, 06:32 AM | #1 |
Registered Member
Join Date: Jan 2000
Location: Feeding Hills, MA
Posts: 114
|
C&L Users or MAF Experts
Just a couple of stupid MAF questions,
1) Where do you buy stock MAF electronics when they go bad, all that I can find is the entire meter. From Ford: $169 + $90 Core Auto Zone $79.99 + $60 Core (some brand I never heard of) Auto Palace $100 + $? (brand X) Should I just go with the ford part? Is it that much better? 2) When installing the electronics in to the C&L do you need to use dielectric grease? Thanks, |
09-14-2001, 07:28 AM | #2 |
Procharged!
Join Date: May 1999
Location: Hanover, PA
Posts: 1,539
|
Well I really don't know what to say, but I would think the Ford parts are the best. However the Auto Zone parts are most likey Ford parts that have been refurbished.
I just took the old electronics off and installed them in the new meter, I did use a small dab of dielectric grease in the connector, never hurts. ------------------ Check Out My Site 91GT,Holley SysteMAX II Kit-Heads 2.02" x 1.60" port matched to a 1262,Anderson N-61,24#,76mm C&L,Full MAC, No A/C or PS or emissions, 12" K&N Filter,RNH PERFORMANCE Ram Air,Ron Davis Radiator,Full Suspension, SPEC stage III clutch, Lakewood SFI bell, S&W 8pt "X" brace,JAZ seats,3:73's,Welds..etc,4:30's and 31 splines coming very soon! [b]12.16 @ 113.5, 1.78 60ft..no traction in the 90 degree |
09-14-2001, 08:02 AM | #3 |
The Photoshop Guru
Join Date: Feb 2001
Location: Mecca, Indiana
Posts: 1,419
|
Is there something wrong with your electronics that is causing you to have to buy a new one?
You might try www.mass-air.com They have all kinds of electronics gadgets. ------------------ Gunning for 12's! Buy your parts here ICQ# 42269241 |
09-14-2001, 09:20 AM | #4 |
Registered Member
Join Date: Jan 2000
Location: Feeding Hills, MA
Posts: 114
|
I looked at the Auto Zone meter no name brand I didn't feel to confident buying it, I am going to get the Ford part. I have gotten several codes, and after doing some searching I believe that the MAF sensor is bad. Thanks |
09-17-2001, 10:01 AM | #5 |
Registered Member
Join Date: Jan 2000
Location: Feeding Hills, MA
Posts: 114
|
I tried www.mass-air.com and they have just the electronics, they are new ford parts for only $119. I ordered it
So, I will let you know how it works. Thanks |
|
|
Similar Threads | ||||
Thread | Thread Starter | Forum | Replies | Last Post |
User's Rides... Think about it.... | Hammer | Modular Madness | 2 | 07-23-2002 06:20 PM |
Attn: Dan. "Users Rides" section only shows 2 users. | Fox Body | Blue Oval Lounge | 2 | 02-11-2001 01:11 AM |