Threaded Mode
© Copyright 1995 thru 2008 - The Mustang Works™. All Rights Reserved.
MustangWorks.com is designed and hosted by Aero3 Media.
MustangWorks.com is designed and hosted by Aero3 Media.
03-12-2002, 05:42 PM
|
#1 |
|
Registered Member
Join Date: Oct 2000
Location: Ontario canada
Posts: 446
|
o2 sensor removal
ok i just fixed a brocken bolt on my turbo flange and noticed that i needed to braze a spot on the exhaust. I figured i should check the o2 sensors the left side came out easy (never sieze still there ) but the right side was (is ) stuck so i had the torch i heated up the bung and tried removing wouldnt turn sprayed with wd 40 no luck put on vise gripps and hit with hammer brock o2 sensor.
left in disspair . both sides are threaded the same right . what short of cutting and welding in a new bung have you guy's tried. still half a foot of snow here but must have things fixed when the track opens.
__________________
89 with 331 t3'/t4 hybrids. upr Suspention worked out finnaly . 9.89 144 mph . |
|
|
| Thread Tools | |
| Display Modes | Rate This Thread |
|
|