MustangWorks.com : Ford Forums - View Single Post

BilLster · 03-12-2002, 05:42 PM

ok i just fixed a brocken bolt on my turbo flange and noticed that i needed to braze a spot on the exhaust. I figured i should check the o2 sensors the left side came out easy (never sieze still there ) but the right side was (is ) stuck so i had the torch i heated up the bung and tried removing wouldnt turn sprayed with wd 40 no luck put on vise gripps and hit with hammer brock o2 sensor.

left in disspair . both sides are threaded the same right .

what short of cutting and welding in a new bung have you guy's tried.

still half a foot of snow here but must have things fixed when the track opens.

03-12-2002, 05:42 PM	#1
BilLster Registered Member Join Date: Oct 2000 Location: Ontario canada Posts: 446	o2 sensor removal ok i just fixed a brocken bolt on my turbo flange and noticed that i needed to braze a spot on the exhaust. I figured i should check the o2 sensors the left side came out easy (never sieze still there ) but the right side was (is ) stuck so i had the torch i heated up the bung and tried removing wouldnt turn sprayed with wd 40 no luck put on vise gripps and hit with hammer brock o2 sensor. left in disspair . both sides are threaded the same right . what short of cutting and welding in a new bung have you guy's tried. still half a foot of snow here but must have things fixed when the track opens. __________________ 89 with 331 t3'/t4 hybrids. upr Suspention worked out finnaly . 9.89 144 mph .