Linear Mode
© Copyright 1995 thru 2008 - The Mustang Works™. All Rights Reserved.
MustangWorks.com is designed and hosted by Aero3 Media.
MustangWorks.com is designed and hosted by Aero3 Media.
02-01-2003, 12:36 PM
|
#1 |
|
Registered Member
Join Date: Oct 1999
Location: Upland, CA
Posts: 16
|
Problems installing aluminum rack bushings
The directions say to cut the tubes that pass through the K-member so they protrude slightly into the rack when installed. Unfortunately, I cut one side too short. It sits flush with the K-member when installed. How critical is that fit? I have not cut the other side yet, so I am making sure I mark that one correctly so I don't cut it too short.
Will it be ok or will I need to get a new tube? Is that a dealer only item? Thanks, Eric |
|
|
 |
|
|
Similar Threads
|
||||
| Thread | Thread Starter | Forum | Replies | Last Post |
| Clutch and syeering rack problems | Just me | Windsor Power | 4 | 09-26-2003 05:26 PM |
| What do offset rack bushings do? | blueneonman1 | Windsor Power | 4 | 11-14-2001 10:37 PM |
| installing bushings help! | glxstang | Windsor Power | 6 | 09-30-2001 08:43 PM |
| Do I have to remove rack to install bushings? | LOCASH | Windsor Power | 1 | 01-28-2001 11:47 PM |
| Offset Rack Bushings? | fordgasm | Windsor Power | 1 | 01-09-2001 06:50 PM |