Threaded Mode
© Copyright 1995 thru 2008 - The Mustang Works™. All Rights Reserved.
MustangWorks.com is designed and hosted by Aero3 Media.
MustangWorks.com is designed and hosted by Aero3 Media.
01-12-2006, 05:01 AM
|
#1 |
|
CAR9FAN
Join Date: Mar 2004
Location: m.d
Posts: 103
|
Bent Push Rods Help
Hello, I got 2 bent push rods on #5 cid on intake and EXT valves they were bent so bad that both roller rockers were off, I was doing my burn out and thats when it happen I think i might have over revved the motor? could the timing being off cause this or loose roller rockers? AnyAdvice Thanks Car9fan
__________________
MY HOME PAGE |
|
|
|
|
Similar Threads
|
||||
| Thread | Thread Starter | Forum | Replies | Last Post |
| 289 bent push rod | Emberglo66 | Classic Mustangs | 4 | 04-16-2004 07:06 PM |
| TFTW heads and push rod lengths? | Rev | Classic Mustangs | 4 | 11-23-2001 07:50 AM |
| AFR Push Rods | evilmustang | Windsor Power | 8 | 11-23-2001 07:18 AM |
| Push Rods...new ones or not | David Fulford | Classic Mustangs | 2 | 08-03-2001 10:39 AM |
| 351W Connecting Rods | BrainSandwich | Classic Mustangs | 3 | 11-04-1999 10:15 PM |