Threaded Mode
© Copyright 1995 thru 2008 - The Mustang Works™. All Rights Reserved.
MustangWorks.com is designed and hosted by Aero3 Media.
MustangWorks.com is designed and hosted by Aero3 Media.
03-13-2001, 01:07 AM
|
#1 |
|
Dirk Diggler
Join Date: Feb 1999
Location: SLOATSBURG, NY
Posts: 1,931
|
how high can i rev the roller motor safely???
with my current combo and mt ported heads and intake along with my cam and tb i should still be making good power above 6250..if i get a rev extender or some kinda pms or chip to eliminate the stock rev controler(i will control rpm limit by spark via accel box) what can i bring my car up to..my buddy said with his carbed roller motor the guy said 7k is not a problem..also is not comp cams comming out with newer heavy duty lifters for higher rpms????i will not think to rev my car higher than stock cpu will alow until a dyno says i need to but im just asking right now..thanks in advanced
------------------ 1987 black notch(ex 4 banger) DSS 306 w/ main support...Elderbrock 6028 heads..gt-40 intake..24# injectors...70 mm tb..77 pro-m...accel 300+..mac full legnth..tremec w/ pro5oh...full MAC exhaust,off road h-pipe,long tubes, catback...ron davis radiator..subframes, control arms...CFDF II..o yea holley FPR sucks..dont buy one.. AIM=onesillynotch |
|
|
|
|
Similar Threads
|
||||
| Thread | Thread Starter | Forum | Replies | Last Post |
| Adjusting Length of high idle on Carb 5.0 | twilightcall | Windsor Power | 8 | 08-06-2003 08:31 AM |
| building a stroker need advice on solid roller or hydrallic roller cam ?? | Mustangboy89 | Windsor Power | 4 | 06-06-2003 02:10 PM |
| Solid Roller ? | STROKER BILLY | Windsor Power | 5 | 11-19-2002 12:04 AM |
| 351W roller conversion | Capri306 | Windsor Power | 4 | 02-14-2002 04:49 PM |
| hydraulic roller valvetrain for HP street?? | Stang_ROTY | Windsor Power | 2 | 04-27-2001 01:09 AM |