How much power do you think ill make?
 

O.K. ladies and gentlemen. I am going to install aluminum gt-40ys that are right now in my garage. Based on my current setup in my signature, how much power do you think ill be making? im currently at 225rwhp@4750RPMs and 284rtq@3500RPMs. Also, what do you think ill run? I only run on street tires and never bother with slicks(cuz my car is made fro street use, not track use) and i am not going to along with a cam due to gas mileage. I just have decent mileage now. The next step after this will be suspension. Everyone says to get subframes but never did I hear a whisper about these things from people in person, only on here. But any help is good help.

------------------
94' Stang GT Convertible --Cobra upper&lower, Mac cold air w/K&N, BBK equal length shorties, BBK offroad H-pipe, American Thunder cat-back, BBK T/B 65mm, 24lb injectors, Pro-77mm MAM, pulleys, aluminum driveshaft, 3.55s, Steeda Tri-Ax shifter, adjustable fuel regulator 14.4@100 MPH on G-tech;96 at track. (Sad, i know. i have stock heads)

The project car "Stone Cold Pony" in MM and FF as just about the same setup as you and I both have is about 262rwhp on the dyno. The difference is that it has a cam and is a AODE so you can kinda guestemate from that. That's what I do since the wait to get on a dyno is about 4months where I live.

------------------
TFS twisted wedge heads, TFS street intake, Lunati cam .500/.510 218/226, BBK FPR
BBK shorties, BBK 70mm tb, Pro-m 75mm, ASP pulleys, FMS 3:73, Transgo shiftkit
Flowmasters, Bassani x-pipe, K&N FIPK, FMS 1.6 roller rockers, 9mm wires,24lbs injectors,
190lph fuel pump, MSD cap and rotor, 18" wheels w/street tires