Roller Rockers, bad?

HiFlow5 0 · 04-14-2002, 12:47 PM

I'm not too sure if this is suppose to happen, but are roller rockers suppose to move side to side? I started inspection stuff really close today and happen to wiggle the rockers. They make a clicking sound when moved side to side, but are tight and don't have any play up and down, is this normal? I also noticed on the #5 cylinder that the rocker on the exhaust side was hitting the valve cover cause of its movement side to side.

If the rockers are bad and I get knew ones, would 1.72 rockers work on my car with the stock heads and E cam?

Thanks all, Craig

Doctor DeBo · 04-14-2002, 01:35 PM

There shouldnt be any side to side movement with the rockers torqued to spec and the lash set.I would stay with 1.6s with your set up but 1.7s wouldnt be a problem either.

04-14-2002, 12:47 PM	#1
HiFlow5 0 Registered Member Join Date: Mar 2000 Location: Springfield, Ma, usa Posts: 706	Roller Rockers, bad? I'm not too sure if this is suppose to happen, but are roller rockers suppose to move side to side? I started inspection stuff really close today and happen to wiggle the rockers. They make a clicking sound when moved side to side, but are tight and don't have any play up and down, is this normal? I also noticed on the #5 cylinder that the rocker on the exhaust side was hitting the valve cover cause of its movement side to side. If the rockers are bad and I get knew ones, would 1.72 rockers work on my car with the stock heads and E cam? Thanks all, Craig __________________ NewEngland Auto www.baystategearheads.com -91 Mustang Coupe, ex 4cyl (sold) -99 F150, 3" lift, 35" Procomps, Magnaflow exhaust

04-14-2002, 01:35 PM	#2
Doctor DeBo Registered Member Join Date: Feb 2000 Location: Newnan, GA, UnitedStates Posts: 83	There shouldnt be any side to side movement with the rockers torqued to spec and the lash set.I would stay with 1.6s with your set up but 1.7s wouldnt be a problem either. __________________ 92LX 5.0 Hatch,4.10 gears Auburn Pro,Mosser axels,alum drive shaft AOD hi ratio gear set,3200 stall TCI conv,Bassani long tube headers/cats,2 chamber flow masters,2.5inch exhaust,331 stroker,alum GT40 heads ported,Omega 1.7 roller rockers,JE forged pistons,Eagle rods,E cam,GT40 upper/lower intake,70mm mass,73mm Pro M bullet,MSD ignition,Cartech fuel sys w/external Aeromotive fuel pump,30lb injectors,Vortech S trim,Tubular front end,D&D coil overs up front

Similar Threads
Thread	Thread Starter	Forum	Replies	Last Post
Roller rockers for stock heads	QuantumMotorsports	Windsor Power	1	07-14-2003 03:15 PM
roller rockers	bobtodd	Windsor Power	4	04-07-2002 01:34 PM
reg rockers or roller rockers??	Chevysucks	Windsor Power	1	12-05-2001 08:17 PM
1.6 roller rockers	David Fulford	Classic Mustangs	6	04-22-2001 08:24 AM
Valve Springs & Roller Rockers	StreetStang37	Windsor Power	4	04-17-2001 03:54 AM