Pinout on O2 Sensor
Hello Technical Geniuses,
I just joined the Forum & hope you wonderful folks can help.
I just acquired a Bosch O2 Sensor w/OEM connector to hook up to my new Autometer Air/Fuel Meter. From the Front, the connector looks like:
. .
.
when the clip is at the top.
Two white wires go to the top pins, & a black wire go to the bottom pin. Which is the signal, heater, & ground?
My manual's on loan, PLEASE help!
I'm using a 3rd sensor, so as to not interfere w/the signal to the EFI.
TIA, Larry
|