Threaded Mode
© Copyright 1995 thru 2008 - The Mustang Works™. All Rights Reserved.
MustangWorks.com is designed and hosted by Aero3 Media.
MustangWorks.com is designed and hosted by Aero3 Media.
09-09-2001, 11:14 PM
|
#1 |
|
Guest
Posts: n/a
|
play in T-5 input shaft.
Putting my tranny in today, I noticed that the input shaft has over 1/4" movement side to side...
this isn't normal is it??? it's been so long. after i got it in and took it for a test drive, i noticed oil leaking from the front of the bell housing, again... All the gears seem tight and the trans isn't making any noises... I suppose i need to pull it and replace the bearing??? ------------------ Black,84 GT,ground effects,shorty headers, 'open' dual exh.,302 HO(no pollution control crap)bored .060, 10.5" clutch, T5,89 ported heads, edelbrock Performer manifold, Edelbrock 2122 cam, 600 Holley, high volume oil pump, front P235/60/R15's, rear P245/60/R15's..... Some day (3:73 gears & N2O)!!! will this ever end???? |
|
|
|
Similar Threads
|
||||
| Thread | Thread Starter | Forum | Replies | Last Post |
| Input shaft ???? on T-5 | lxnospower | Windsor Power | 3 | 04-09-2004 12:20 PM |
| broken input shafts (plural!) | DrJaysBlown5.0Mod | Modular Madness | 4 | 03-17-2004 01:54 PM |
| input shaft ? | WADS56 | Windsor Power | 1 | 08-26-2002 01:47 PM |
| Input Shaft | Phantom5oh | Windsor Power | 10 | 05-31-2002 01:51 PM |
| Distributor alignment with Oil Pump Shaft | Dopie | Classic Mustangs | 4 | 12-03-2001 06:59 AM |