Threaded Mode
© Copyright 1995 thru 2008 - The Mustang Works™. All Rights Reserved.
MustangWorks.com is designed and hosted by Aero3 Media.
MustangWorks.com is designed and hosted by Aero3 Media.
04-03-2002, 10:27 AM
|
#1 |
|
Registered Member
Join Date: Mar 2000
Location: minneapolis, mn
Posts: 158
|
polishing stock parts?
I have my stock throttle body and egr spacer off of my car. Does anyone have any recommendations on polishing them? I would by a polished one but most are a bit more than i want to pay. I think the stock one is 60mm and i wouldnt be gaining any performance if i went up to a 65 or 70mm on a stock intake. I have a polished stock intake and would like the TB and EGR to match it....come to think of it, i would have to polish the air bypass valve housing as well. I am just not sure the best way to go about getting started at that. Any ideas?
__________________
1991 LX coupe,AOD, red, 80k, K&N, MAC cat back, MAC off-road X, Autometer Gauges, BBK Ceramic unequals, fully polished upper intake, fuel rails, and egr, working on installing.....MM full length subs, H&R sport springs, MM Lower control arms, MM caster camber plates, bilstein shocks, struts. |
|
|
|
|
Similar Threads
|
||||
| Thread | Thread Starter | Forum | Replies | Last Post |
| Which is your favorite general auto parts store? | Fox Body | Blue Oval Lounge | 28 | 12-07-2017 11:18 AM |
| Stock Cam | gtsr515 | Windsor Power | 1 | 04-03-2002 10:28 PM |
| Question about stock cam specs | MustangGT1990 | Windsor Power | 11 | 04-03-2002 10:04 AM |
| Pro-M on stock motor? | NotchJohnson | Windsor Power | 3 | 03-23-2002 10:28 PM |
| LT's vs. shorties vs. stock headers | jonnyk | Windsor Power | 9 | 01-01-2001 11:28 AM |