Threaded Mode
© Copyright 1995 thru 2008 - The Mustang Works™. All Rights Reserved.
MustangWorks.com is designed and hosted by Aero3 Media.
MustangWorks.com is designed and hosted by Aero3 Media.
04-14-2005, 11:56 AM
|
#18 |
|
Registered Member
Join Date: Nov 2001
Location: PHILA. PA USA
Posts: 469
|
Re: poor dyno numbers from 408 :(
I looked at your build sheet. The xe284h cam is part number 31-250-4. Comp Cams site says any cam with a 31 prefix uses the old firing order 1-5-4-2-6-3-7-8. If you are useing 1-3-7-2-6-5-4-8 this is your problem. I've seen it before.
|
|
|
|
|
Similar Threads
|
||||
| Thread | Thread Starter | Forum | Replies | Last Post |
| casting numbers | Sheldon | Built Ford Tough | 5 | 08-21-2002 05:58 PM |
| Powerdyne Dyno numbers and continuing frustration | 1995MGTS | Windsor Power | 17 | 03-31-2002 12:59 PM |
| How are these oil pressure numbers? | 88COBRA | Windsor Power | 3 | 02-26-2002 01:02 PM |
| Numbers from leakdown test | exgmguy | Windsor Power | 8 | 10-04-2001 08:32 PM |
| Intake Flow Numbers? anyone have them | NewAge 5.0 | Windsor Power | 0 | 09-25-2001 12:05 PM |