Bolt sizes for tranny swap

firststang · 01-22-2003, 04:13 PM

does anybody know the bolt sizes/length for all the components needed for an aod/tremec tranny swap. flywheel, flex plate, bellhousing, etc. just thinking having the right bolts on hand will make the job a little bit easier. thanks, also, i see the aod to t5 conversion, is the tremec 3550 about the same?

firststang · 01-22-2003, 10:15 PM

this is for a 93 gt 5.0 thanks

bigredstang · 01-24-2003, 03:20 PM

When I switched out my AODE to the Tremec in my 95 the only thing I needed was different flywheel bolts and for some reason, with a Mcloud blow proof bellhousing different tranny to bellhousing bolts. I think Tremec supplies 7/16" bolts but I ended up needing 1/2". Also I had to very carefully open the bolt holes in the mounting ears of the Tremec. I think that I had to trim a piece off the case of the tranny but I dont remember why.

01-22-2003, 04:13 PM	#1
firststang Registered Member Join Date: Jan 2003 Posts: 3	Bolt sizes for tranny swap does anybody know the bolt sizes/length for all the components needed for an aod/tremec tranny swap. flywheel, flex plate, bellhousing, etc. just thinking having the right bolts on hand will make the job a little bit easier. thanks, also, i see the aod to t5 conversion, is the tremec 3550 about the same? Last edited by firststang; 01-22-2003 at 10:18 PM..

Similar Threads
Thread	Thread Starter	Forum	Replies	Last Post
Problem, Bolt Removal	KrivoK	Classic Mustangs	2	12-19-2003 07:26 AM
Cobra Engine Swap...Ways to improve my 98 GT...	xtrememach1racer	Modular Madness	3	10-31-2002 11:23 AM
66 T to 5.0 swap	yenrab	Classic Mustangs	1	03-23-2002 11:12 PM
Rearend swap	H'YAMULE	Classic Mustangs	0	02-19-2001 09:48 AM
2.3 turbo swap	frankiebonzz	Small Ponies	0	06-01-2000 07:44 PM

01-22-2003, 10:15 PM	#2
firststang Registered Member Join Date: Jan 2003 Posts: 3	this is for a 93 gt 5.0 thanks

01-24-2003, 03:20 PM	#3
bigredstang Registered Member Join Date: Mar 2000 Location: lincoln, NE Posts: 80	When I switched out my AODE to the Tremec in my 95 the only thing I needed was different flywheel bolts and for some reason, with a Mcloud blow proof bellhousing different tranny to bellhousing bolts. I think Tremec supplies 7/16" bolts but I ended up needing 1/2". Also I had to very carefully open the bolt holes in the mounting ears of the Tremec. I think that I had to trim a piece off the case of the tranny but I dont remember why.