Timing chain cover help - new cam.
 

I'm putting the 2031 in - I have a question on re-installing the timing chain cover - is there some kind of trick to getting the cover back on without my oil pan gaskets sliding off or not lining up when I push it over that key on the bottom right hand bolt of the cover?
I'm done for the night, but I don't want to get stuck tomorrow - I wanna drive!


------------------
86 GT, GT40P heads, Cobra cam, 1.7 RR's, Cobra intake, 65mm TB, 73mm Vortech, 24# injectors, MAC GT40P headers, 2-1/2" BBK H-pipe (w/cats), Flowmasters, 3.55s.
**************
Crane 2031 on order

I used sealant on the gasket to the oil pan, and let it set up. Then installed the timing cover (again using sealant). I haven't had any oil leaks.

i agree with SSPmust, i think that is what my friend did that was his job though... it took a while before it went on right... how did the rest of the install go??? the hard part is done... it all dow hill from here... cant wait to see it!!! the guy at work said it sounded reaaaal good before.... see yeah around!!! patrick

------------------
PPG Torch Red 95GT, Ported Explorer Intake, E-303 cam, 75mm MAS, BBK Adj. fuel Reg & gauge, BBK Shorty Headers, BBK H-pipe, March Pulleys, 2 Chamber Flowmasters, Kenny Brown 6 point Roll cage, Kenny Brown Panhard Bar, Powerslot Rotors, Eibach Sportline Springs, 180* Thermostat, 1/2 Plenum Spacer, MSD 6AL, MSD Master Blaster, MSD 8.8 Wires, 19# Racing Injectors, AFS 10.5" Cobra R's, Nitto 555's, Eclipse & JL Stereo System... I just sold My K&N, It looks funny with Stock Air Box & filter!!!