Stock heads
 

Hey.
I was wondering what I can get out of a set of stock heads that have been fully ported, polished, valvejob, new springs valve locks and guides. Any ideas?? thanks


------------------
347 Stroker Motor: Balanced, A9P Computer, Cobra Transmission, Extrude Ported and Polished Upper and ported Lower, GT40 Milled Ported and Polished Heads, B303 Cam, BBK 1 5/8 Headers, 30lb Bosch Injectors, Holley Fuel Regulator, March Underdrive Pulleys, Perma-Cool Fan, 3-Core Radiator, Accel Performance Coil, Accel 300+ Racing Wires, Ram Air, K&N Filter, 79mm Mass Air Unit, FlowMaster Exhaust w/BBK Offroad H-Pipe, Hurst Short Throw Shifter, 3:55 Gears, Ram Clutch, Cross Drilled Rotors

Hello???

kinda hard to say w/ out some numbers....
If you caould tell someone that they were good for 30 hp...then i'd say about $250-$300
maybe more....but they will need a valve job(unless never been on car) and thats about another $150...so that put's someone at $400.
A few more bucks and coulda had some better heads. But lots of people are looking for that extra 25-30 horses for cheap.

------------------
4.10's,long tubes & 75 shot...Goes 12.50's
Check it out at http://www.burnouts.webprovider.com

11's coming soon!!!!
Heads,intake and cam are all here

I believe the quickest E7 headed car
I ever heard of was a gutted coupe running
only subsframes, 3.73's, ported stock intake,heads.Stock cam,ect... it was like a 12.60 or thereabout.