improvements with ported stock heads
 

this past weekend, a friend and myself ported what seemed to be about 10 pounds out of my stockers, we took the exhaust ports out almost all the way to the fel-pro 1415's dimensions, (1.25x1.48 i believe) whick was about 1/8" all the way around, we also ground out the bumps inside each exh port, why Ford put them there I don't know, we also gasket matched the lower explorer intake with the intake ports on the heads as well as polished every port, it seems to me like i should gain atleast 15-20hp by taking that much material away, 2-3tenths hopefully, has anyone here done this and have good results? my last run of 13.99 was before the removal of the swaybay, 1.7rockers, explorer int. w/ported lower and the ported heads, so if i can find traction do you guys think a 13.50's are within my reach?

------------------
88 Notchback 5.0, 3.73's, Explorer intake, pulleys, Crane 1.7's, BBK headers, off-road H-pipe, flowmasters, subframe connectors, 65mm TB, shift kit, March ram air kit, motorsport wires, MSD coil, upper and lower control arms, 155lph fuel pump, cheap 2800 stall, Crane Adj.FPR, best time- 13.99@99.75, not yet tested times after rocker and intake install

it'll take 50 horses to get it.....
You might...gonna be close.


------------------
4.10's,long tubes & 75 shot...Goes 12.50's
Check it out at http://www.burnouts.webprovider.com

11's coming soon!!!!
Heads,intake and cam are all here

Should get there easy. I was running that on a fully weighted Gt with a stock motor. Just drive it hard and make it hook. Slicks really help.

------------------
87 GT, 4 inch cowl hood,17x9 Cobra R's/255/45's,GT-40 heads,long tubes headers,h-pipe,Flows,BBK cold air, Mass air,70mm MAF, 1.7's, 1" spacer,underdrive pulleys,Pro 5.0, King Cobra, Adj. fuel Reg., Lakewood Lift Bars,50/50's,subframes, 4.10's.
Best time 12.96
Best MPH 103.42
Best 60' 1.695

Visit my site at:
http://www.geocities.com/cobrar93_2000/MyPage.html

well when i ran the 13.99 i was running 100mph trap speeds, which means with that setup i shoulda been a little faster, just couldnt hook, i have a set of hoosier 10" ers that im gonna be using next time out, i think i coulda ran a 13.8* with the slicks before but my pipes are in the way, i'll fix that and go for it, any other little stuff i could do, im broke by the way so all i can afford is the gas

ttt