My 5.0 fell off! HELP!
 

my 5.0 emblem on the passenger side fell off while i was drying my car, what should i use to make sure it doesn't fall off again??

------------------
SHaFTed

91GT, Flows, 70MM BBK TB, K&N, Hurst short throw, T5, 17" Lexani Roma, 235/40/R17 on front, 255/45/R17 on back, mach1 hood, LX tail lights, bright red!

I wouldn't mess with putting it back on although you probably could with some epoxy or clear silicon. I would just go to Ford and get a new one to put on. They are not that expensive.

------------------
88GT 5-speed
Mods: Cervinis Ram air hood 3.73 gears, King Cobra clutch, Pro 5.0, March alum. Pullies, DynoMax Cat-back, WMS Xtrac subframes, 16" Ponies.
"Nip it in the Bud"
My Webpage

Yes, just buy a new one, last time I bought them I paid $11 each at ford...

You could always use some 3M double sided tape. Isn't that what they come with? I think BASF makes the same type of stuff. It's just as good as epoxy.

------------------
1984 1/2 GT350 (#842 Hatchback w/ T-tops), 302HO, Comp cams Xtreme Energy cam, Carter 625cfm carb, Weiand Stealth intake, MSD distributor, MSD coil, FMS 9mm wires, 1 5/8" MAC unequal shorties, 2 1/2" MAC Prochamber H-pipe, Flowmaster 2 chambers, KYBs, 16"x8" 4 lug Cobra Rs, Falken 245/45ZR16s