time to change cams
 

Do you guys think that there`s a better choice of cams than my F303 for my combo?
If so what would you recomend.If not,why?

------------------
85 mustang coupe with a 88 block,edelbrock 6022 aluminum heads,crane roller rockers,aluminum driveshaft,C-4 trans,3500 stall,3.73 gears,lakewood traction action liftbars with air bag in right rear spring,longtube headers,flowmasters,
weiand stealth intake,600 holley,
best e.t. 1/8 mile 8.10
best mph. 85.20
best 60 foot 1.73...

With your mild mods, I would recommend no more than an E303, or leave it stock and not change it at all. Running the F303 with your combo is slowing you down. You may not want to spend the $$$ to replace it w/ a milder one......maybe you'd rather build into it (unless $$$'s an issue.)

------------------
'90 LX 5.0; 12K original miles (no sh*&); 3.55 gears; pulleys;Edelbrock Performer Heads; BBK shorties; MSD 6AL box w/ blaster 2 coil; Motorsport E303 cam; Pro-M 75mm MAF; BBK 70mm TB; Eibach spring kit; Southside welded subs; K&N cone filter charger; Hurst shifter; fiberglass turbo hood; A/C-less; rear seat-less; cat-less; 2 chamber Flos; Corbeau racing seats (fronts);
30# injectors; 190 lb fp; FPR; TFS track heat Intake - 12.513 @ 112 mph (Pre-inj/fuelpump/FPR/intake)

I have an F303 and it seems to work fine with my mods. I don't see it hurting you with the mods you have. They are comparable in a way to what I have in my EFI setup. You do have the aluminum heads though which should help out even more. I just have the stock ET7E's with some work done to them. Anyway, the F works fine for me and I gotta say I love the idle http://www.mustangworks.com/msgboard/biggrin.gif

------------------
Too much to list. Best ET on the car so far with stock 2.73 gears - 13.73@102mph

Indiana Stangers Association
Buy your parts here
ICQ# 42269241

For a naturally aspirated engine you'd need more compression to be ideal for the F cam. You may actually gain by going to a cam with less duration, but I think the F cam won't hurt you too much. Since you're running a c4 with 373's you've got plenty of gear to keep it up high, I think you're streetability may not be at its best but powerwise you shouldn't be hurtin that bad.

------------------
GT-40 heads (ported, polished, + milled), B303 cam, 1.7rr's, JE pistons, Offy intake, Carter AFB 625cfm carb, Flowtech 1 5/8" shortys, Flowtech X-pipe, MAC Flowpath exhaust, MAC pulleys, 373's, subframes, Eibachs+Tokicos, B+M ripper, FMS Clutch, Zoom Quadrant+cable, 17" CSA Ultra rims, 235/45ZR17 Yokohama AVS S4's, MSD 6A ignition+coil, FMS 9mm wires, Carbed, Naturally Aspirated, and Nasty!