Differance in ET after cam and intake?
 

I finally got me new Edelbrock Performer intake and Crane Compucam 2031 cam. I will be putting them in this week and running the car next friday hopefully. What do you guys think I will pick up in the 1/4? My best now is in the sig. How about MPH? I know that the stock intake is really holding back my GT-40 heads now. Also how much should I bump my fuel pressure up? if any? Thanks

------------------
87 GT, 4 inch cowl hood,17x9 Cobra R's/255/45's,GT-40 heads,long tubes headers,h-pipe,Flows,BBK cold air, Mass air,70mm MAF, 1.7's, 1" spacer,underdrive pulleys,Pro 5.0, King Cobra, Adj. fuel Reg., Lakewood Lift Bars,50/50's,subframes, 4.10's.
Best time 12.96
Best MPH 103.42
Best 60' 1.695

Visit my site at:
http://www.geocities.com/cobrar93_2000/MyPage.html

You should definately get the car to a mid-12 with the Edelbrock and cam installation.

I've seen MANY cars with aftermarket intake,GT-40 heads,aftermarket cam,exhaust mods,gears,...run in the 12 second range with no problem.

Don't raise your fuel pressure.Make some runs at the track to determine where you should set fuel pressure.Keep records of where it's set at and go accordingly.When the car starts to slow down in MPH,then go back to the previous pressure setting.

------------------
http://home.dencity.com/Mustanguy/avatar.gif
Paxton Blown 87GT
ICQ#112698436

[This message has been edited by Mustanguy (edited 05-04-2001).]

hows about you just do it, and tell us what the difference was! http://www.mustangworks.com/msgboard/wink.gif
Q

------------------
Quin, 87 GT,306,forged pistons,edelbrock head\intak,steeda#18cam,1.7rr,MSD Blaster tfi coil,A9L,pro-m75mm,24#inj,accufab65mm,2.5"pipes,hooker headers,dynomax exhaust,3.73 gr,110 lph fp,180*therm,moroso cold air,ASP pullies, weld rims

The beast has awoken!

I see your shwartz is as big as mine, now lets see how well you handle it!