What Can I Expect From This
 

Hi, i was wondering what i could expect from my combo here and if you could tell me if it will all work together good

every part is brand new except for the block.

Its a 302 bored .040 over, I have edelbrock performer rpm heads with 2.02 intake valves, edelbrock performer rpm airgap polished intake, holley 750 dp 4 barrel, msd pro billit distributer, msd ignition box 6al, blaster 2 coil, comp cam (magnum #280h I .512 E .512 280 280) comp timing set, comp pushrods, comp full roller rockers. mac shortie headers ceramic coated.

Will this set up work together? Any info will be very helpful. This is my first time building a semi-race motor.

I'd say it sounds like a good combination ... good power output and still streetable ... you could probably get buy with a 650 on the carb but this leaves you room to grow.

what kind of compression ratio with that combo give you ?

I think it looks good. The carb is a litle big a 650 would be better but you have it so use it.

any guesstiments on hp?

Havent fired it up yet. I just bought the edelbrock nitrous kit for it too. pn#70001. It is the 50 75 100 shot kit. If I run the 100 shot, do you think it will put me in the 12's? Can't wait to turn the key.....another week.look at the pics below.