Ballast resistor and should i have one
 

In the durra spark diagram one wire is shown as a resistor wire with 1.2 ohms because I'm tapping into the hot wire on the 92 2.3 harness to make the durra spark system work should I install a ballast resistor some where

Re: Ballast resistor and should i have one
 

WTF?? I can't post just no. You don't need a ballast resistor.

Re: Ballast resistor and should i have one
 

What’s the purpose of the resistor wire or ballast?

Re: Ballast resistor and should i have one
 

Some ignitions are meant to run on 8-9 volts for extended duty. At start up when the ballast resistor or resister wire is cold, a full 12 volts is delivered at start up for easy cold starts. As the resistor warms up, the voltage is lowered to the 8-9 volt range. With some ignitions, delivering the full 12 volts all the time will burn out some part of the ignition system. My recommendation is to use whatever resistor (or none at all) that the manufacturer of the ignition specifies.

Rev