fuel line
 

I'm getting ready to install 24# injectors and I want to also change the fuel lines. I would like to get the steel braided hose line with the threaded ends. Does anyone have this type of setup? Is there a simple kit out there for this?

Re: fuel line
 

If you're looking for a packaged kit, Aeromotive has a complete kit. It'll run you about $1000 though, including the sumped tank. If you're just looking to snaz up the engine compartment, then you can transition from the factory lines to braided line by using the special push-lok to AN fittings availabe from a few different sources (UPR, Aeromotive, Earls, Downs, etc). You're best off to put a set of aftermarket billet fuel rails on at this point too, to get rid of the factory push-lok fittings.

Re: fuel line
 

Thanks for the info. I think I'm going to buy Vortech fuel rails and buy the braided hose lines and the correct fittings for the connections from Earls. I just need to figure out the correct connectors.