Please, Please, Please Help!!!!!!
 

I just did a Auto to 5 speed conversion. I got it all hooked up ready to....so I thought. Turned the key nothing. I have the neutral safety switch locked into the correct position ( basically by passing it ). i do not have the the other switch above the gas pedal fully on yet. I have the cplastic that the clutch cable rides on, but not the other side of it that hits the other switch. On my tranny I have two wiring harnesses. One on the side with 4 wires, and one close to the top with two wires. i am guessing one maybe reverse lights and the other that neutral switch. Since this car was auto it does not have a harness to hook it into. Is there a way to bypass that, or am i not correct what it is.Please, any help you can give. I have put in many hours since friday, and am desperate. THANKS

Re: Please, Please, Please Help!!!!!!
 

what year car ?

How did you bypass the ecm ?

For an A9L computer ground pin 30 (light blue w/ yellow stripe) to tell the ecm
the tranny is in neutral.

Re: Please, Please, Please Help!!!!!!
 

the computer was never connected. It is an 86. The computer was disconnected when I got it.

Re: Please, Please, Please Help!!!!!!
 

Your automatic car had a jumper for the neutral safety switch from the factory. If it is not jumpered or the swiotch in place, no crank. Black connector, red wire with light blue stripe.

Re: Please, Please, Please Help!!!!!!
 

Yeah man, what he said. You're not sending 12v to the "S" or "I" (or BOTH!) terminals on the solenoid. Bottom line.

Re: Please, Please, Please Help!!!!!!
 

hello. Well i got it. i ripped the harnes out of the other car and then searched for the same color wires in the old auto. sure enough i found them hidden tucked away behind the stereo. car starts and runs beautiful. now if i could only get this little plastic gear looking thing on the rod behind the quadrent, i'd have a clutch pedal.