how's this setup?
 

Hi,
I am only sixteen, but my parents got me a 1993 mustang gt, and I kinds made a list of mods I want to do, at sometime or another, and I was onwdering if you guys could give me some advice. Here it is: Sub-frame conn, trac. bars, 3.73 gears, 31 spline axles, tremec 5 speed, tfs twisted wedge heads, tfs intake, cam(not sure which one), injectors(probably 36), 70mm throttle body, maf to compliment injectors, 17psi procharger(mwahaha), headers, full exhaust system, fuel pump, probably forgetting some stuff, but thats basically it. What do you guys think? Hopefully, this will probably put out 600hp, but at that power, I will probably blow the block. Thanks!

That combo would make more than 600hp if everything was tuned right. You'd burn the pistons, shoot the rods through the side of the block, break the crank, and if the miracle of the rotating assembly holding together did happen, you'd crack the main webbing on the block and grenade the entire engine.

Other than that, I'd step up to 42lb/hr injectors, alumininum driveshaft, drag struts and shocks, you'll need the biggest slicks you can fit, a full roll cage, C-clip eliminators, an upgraded positraction unit, rear end girdle, drag springs, and a bunch of other stuff.

Nice to dream though! http://www.mustangworks.com/msgboard/biggrin.gif

How would your parents feel about adopting a 35 year old?

Take care
~Chris

------------------
Retired Moderator
MustangNet

My site: JimPorterRacing

RACECAR spelled backwards is RACECAR

HEY !!! Are you ASE Certified ??? If you are, ask me about iATN. The best tool you'll ever have, and it's free !!!

I would probably rebuild the entire engine sooner or later, but I don't know about the block, unless I had to, I wouldn't buy a new block, but a mexican one would be nice. Wait a sec. can't you bolt on that piece that goes over that main journals? Would that improve the block strength? Well, aren't you guys glad I am not into rice rockets? They're just plain ridiculous. Thanks!