anyone shift higher on 3-4 shift?
 

farily recently i did the aod-T5 swap
with my AOD it seemed to run quicker when i shifted from 2nd to 3rd at a higher RPM than 1st-2nd, i had my shift light set at 5300 but on the 2-3 shift i waited just about 100-200rpm later to shift and i was consistently quicker, my question to you guys is should i shift at exactly the same RPM at every shift or should i shift higher when going from 3-4 or 2-3? i now have my light set at 5400 and have only got 3 runs at the track so i havent had a chance to really test and tune it since the swap


------------------
88 Notch, B&M Ripper, 3.73's, Ported E7's, Explorer int. w/ ported lower, pulleys, 1.7RR's, BBK headers, off-road H-pipe, flowmasters, subframes, 65mm TB, March ram air ,MSD coil, U/L control arms, 155lph f/p, Crane Adj.FPR, Nitto drag radials, best 1/4--> 13.76@101.4 on a 2.17 60ft

I think a lot of people actually do the opposite.

They shift at higher rpms from 1-2, then down a 100 or 200 from 2-3 then maybe another 100 to 4th.

Myself I shift at 5800rpms on my stock tach, so somewhere between 4500 and 6500rpms. LOL

that what i do, i shift around 5500 1-2 then drop a bit on each shift when racing, the rpm's drop more in the lower gears so you need to wind it up a bit higher to keep in your power band after the shift

------------------
93-LX: 5 Speed, Flow's with H-Pipe, 3.73's, C&L 76MM Kit, Sub's and K&N.
14.722@ 98.24

[This message has been edited by lx mike (edited 09-15-2001).]

I shift at 6000 on the 1-2, and 5500 from there on out.

SKyler

------------------
-1989 Saleen Mustang #406-
TFS TW Heads, E-303, Edelbrock intake, 70mm TB, 73mm MAF, 24lb injectors, 1 5/8 shorties, Off Road H, 3 Chamber flows, Jaz Race seats, Back seat removed, sub-frames, Roll Cage, and a 80 shot of N20.
12.54@107.4 Motor
332RWHP, 350rwtq

Yup thats were i was shifting at. W/ new cam i hit 6 grand for all shifts now (darn factory rev limiter)

------------------
89 Notch: ASP Pullies,
K&N Air,Transgo shiftkit,Trans. cooler,FMS 3 core , FMS 4:10's, 1.5" cowl, cold air kit, hooker shorties(jet hot coated), O/R H-Pipe, ASP solid mounts, Energy Sus. Trans. Mnt. BBK 70mm TB, MSD 6al, Dual elec. fans, 5.0 Firepower Kit, Scorpion 1.6 RR's, Flowmasters, 73 mm MAF, cobra intake and crower #512 cam,