Backseat
 

How do i take out the backseat of my 93gt for
less weight racing?
thanx

------------------
93gt T-5
Mods:edelbrock heads,gt-40 upper&lower,f-303cam,65mm TB,75mm MAF,24#inj,190lph pump,msd6btm,powerdyne 6lbs supercharger,adj fuel press reg and guage,autometer monster tach with shift lite,drag springs with airbag,aluminum driveshaft,BBK unequal headers,h-pipe,2chamber flowmaster,subframe conn's,3.73 gears.Megabyte jr lower rear control arms,Offroad
H-pipe.Griffin aluminum radiator.Moser 31 spline axles, Auburn Pro unit.Weld Pro Star rims

The bottom you can actually just pull out of mine. The backs are just a few bolts. The ones in the very outside of the backrest are the hardest to get to. Once you get it out you will see that they dont weigh much. I personally dont think it is worth the time to pull them unless you race constantly and carry no passengers.

The bottom seat you have to push on each side halfway between the driveshaft tunnel and side of the car. You have to push back toward the rear of the car and up and they'll pop right up. The rear uppers as mentioned you have to undo the phillips head screws on the rear covering the hinges and then take (i believe a 13mm) to take off the bolts. All that stuff should come out pretty easily. My car came without a rear seat and i also took out all the sound deadening material (including the tarish stuff underneath). The car is probably 100 lbs lighter than stock. I'd recommend it, especially if you want an excuse so you don't have to carry all your friends around in your car (i guess i've saved alot of gas because of this as well, not having to drive as much).

------------------
Mustang Parts Specialties ripped me off, it could happen to you as well.
'84 Mustang 5.0 LX
my LX
'89 Mustang GT
my GT