valve cover clearance
 

would i have enough clearance to run 1.72 roller rockers with a cam with a .512 lift?
on stock valve covers. 91 is the year if needed.

Don't kmow for sure but I highly doubt it. I ran the Ford motorsport "tall" valve covers and I had to remove the baffle.

------------------
Just need the sticker!

Red 1993 GT
1969 351 block w/393 stroker. Edlebrock Performer heads and Performer RPM EFI, FRPP 30lb injectors & Cartech fuel system. JMS chip & MSD ignition.
Dynamic Roller Myte C4, 8 pt cage, Sothside Machine bars & Sub-frames, adj. upper's, 3.73's, Koni rear shocks

You will need to grind the baffle out. The 1.7's put a lot of added stress on the drive train it is better to go with a larger cam and stay with 1.6's.

Where do you cruise in MD?

------------------
Check Out My Site 91GT,Holley SysteMAX II Kit-Heads 2.02" x 1.60" port matched to a 1262,Anderson N-61,30#,76mm C&L,75mm Accufab, Full MAC, No A/C or PS or emissions, 12" K&N Filter,RNH PERFORMANCE Ram Air,Ron Davis Radiator,Full Suspension, SPEC stage III clutch, Lakewood SFI bell, S&W 8pt "X" brace,JAZ seats,3:73's,Welds..etc,4:30's and 33 splines coming very soon!
[b]12.16 @ 113.5, 1.78