94 gt TPS adjustment???
 

I've been trying to check the voltage on my TPS with a digital voltmeter. It reads 0. What is the proper way to check it and once i get the reading how is the TPS adjusted???? Thanks!!!!!

------------------
94GT, cobra intake, 65mm TB, 75mm PRO-M, Mac cold air induction, march underdrive pulleys, Mac shorty headers, off-road H-pipe, Mac cat back, FMS drive shaft, FMS 3:73 gears, Jet chip, kirban shifter, eibach 2" lowering springs, Konig villain 17x8 front 17x9 rear.

get two really small safety pins, and pierce the orange wire with one and the black wire with the other. Attach your DMM pos lead to the clip in the orange wire, and the neg. lead to the clip in the black wire. Turn on the DMM, set to the 5 scale in DC volts. Turn on the ignition. The DMM should read less than 1 volt. Ultimately, you want it set NO HIGHER than .95 volts at idle. You adjust it by loosening the two screws that attach it to the TB, and turning it. If you can't move it enough to get within range, then remove it and carefully elongate the holes. Once you have it set at .95vdc at idle, slowly rotate the throttle while watching the DMM. It should rise smoothly to somewhere around 4.5vdc.

Take care,
-Chris

------------------
Retired Moderator
MustangNet

My site: Peckerwoods Pit Stop

http://homepage.mac.com/pkrwud/.Pict...sc./MyMac.jpeg

My teams site: Jim Porter Racing

RACECAR spelled backwards is RACECAR

HEY !!! Are you ASE Certified ??? If you are, ask me about iATN.